Filter
Top Products
Operating instructions
31
Washing is not spun
properly, water is still
visible in the drum.
Error code
(2 appears.
Drain hose is kinked. Remove kink.
Maximum pumping height
(drain height 1m above the
floor on which the machine
is standing) exceeded.
Please contact customer
service who have a retrofit
kit for pumping to heights of
greater than 1m.
Circulation pump is blocked.
Switch off the machine and
unplug from the mains, clean
the circulation pump.
In the case of siphon con-
nection: siphon is blocked.
Clean siphon.
The fill-in door cannot
be opened when the
appliance is switched
on.
The door is locked for safety
reasons (Indicator next to
K/W (DOOR/LIGHT) button
is off).
Wait until the indicator is
green.
Program protection is set.
Program protection is deacti-
vated
(see "Program Protection").
Remnants of detergent
are building up in the
detergent drawer.
Tap is not fully open. Open tap completely.
The sieve in the coupling of
the inlet hose at the tap is
clogged.
Clean sieve.
The sieve in the coupling of
the inlet hose at the appli-
ance is clogged.
Clean sieve.
Rinse water is cloudy.
The cause is probably a
detergent with a high silicate
content.
No negative impact on the
rinsing results, possibly use
liquid detergent.
When an additional
program button is
pressed, the corre-
sponding indicator
does not illuminate.
The additional program
selected cannot be combined
with the program set.
Make another choice.
Program progress dis-
play flashes constantly.
Program protection is
switched on; the program
selector has been moved
during the washing cycle.
Turn program selector back
to original position
(see “Program Protection”).
Malfunction Possible Cause Remedy