11 Setups
Xerox Phaser 3635MFP User Guide 191
Machine Tests
Should you need to report any faults to the machine, the Xerox Welcome
Center support may talk you through the following machine tests to verify the
performance of the machine and user interface (UI) screen.
Image Quality Test Patterns
Use the scroll buttons to select one of the 19 available test patterns.
Select the Feature button to test either 1 sided or 2 sided printing from the
available trays.
Select the Start Test button to begin the test.
Tools > Device Settings > Tests & Resets > Image Quality Test Patterns
User Interface Tests
User Interface Button Test
The UI Button Test verifies that all of the buttons on the panel are functioning
properly.
1. Ensure that the selection audio tones are enabled - refer to Audio Tones
in the Setups chapter on page 183.
2. Select Start Test to begin the test.
3. Press each button on the panel to the right of the touch screen. A short
audio tone will be generated if the button is functioning properly.
4. Select End Test to end the test. The Test Pass/Fail screen displays.
5. Select the Passed button if all the buttons on the User Interface are
functioning properly. Select the Failed button if any of the buttons on the
UI are not functioning properly.
Tools > Device Settings > Tests & Resets > User Interface Button Test
Touch Area Test
The Touch Area Test verifies that all touch areas on the display are
responding.
1. Select Start Test to begin the test. Then touch the display. If the display
is functioning properly, the selectable area will toggle between white and
black each time the area is touched.
2. Press 1 on the keypad to indicate the test was successful. Press 2 on
the keypad to indicate the test was not successful.
