11 Setups
Xerox Phaser 3635MFP User Guide 173
Select the On button to enable this feature.
Select the Off button to disable the feature.
If this feature is enabled, you will receive a popup while faxing a document,
requiring you to confirm if you want the fax sent immediately.
Dial Tone Volume When the Audio Line Monitor has been enabled, the dial tones are audible
when faxing. Use the scroll buttons on the Dial Tone Volume screen to select
a dial tone volume setting (from 1 - 7).
Transmission
Header Text
The Transmission Header Text screen allows you to input details that will
appear on the header of all outgoing faxes.
Fax Country Setting
From a list of options, select the country in which the machine is installed. This
enables the fax modem settings to match the telephone system of the country.
Tools > User Interface > Fax Service Settings > Fax Country Setting
Receive Defaults
The various options in the Receive Defaults section enable you to customize
the way faxed documents are received.
Tools > User Interface > Fax Service Settings > Incoming Fax Defaults
Auto Answer Delay This tool enables the machine administrator to set a delay time before the
machine responds to a call. This is particularly useful if the machine is
attached to a shared phone line.
The default answer delay is 1 ring. To delay the pick-up, enter a number
between 1 ring and 7 rings using the keypad. Select the Save button to save
the setting.
Ring Volume This feature enables the user to hear a ringing tone from the machine when
an incoming fax is being received.
If you do not want to hear a ringing tone when the machine receives an
incoming fax, select the Off button. If you want to hear a ringing tone when the
machine receives an incoming fax, select the On button. When the feature is
on, you can adjust the volume of the ringing tone by selecting a High, Medium
or Low setting.
Auto Reduction When receiving a fax that is longer than the selected paper, the machine can
automatically reduce the document to fit the paper. To do this, the Auto
Reduction feature must be enabled. Select On or Off as needed.
