![](https://pdfstore-manualsonline.prod.a.ki/pdfasset/9/8c/98c0d5e8-5d94-4e56-84ea-02e16ebfbdc2/98c0d5e8-5d94-4e56-84ea-02e16ebfbdc2-bg9.png)
7
E. EQUIPMENT PREPARATION PRIOR TO OPERATION
1. CLEANING: Prior to leaving the factory, the fryer is tested for proper operation with peanut oil.
After testing is complete, the oil is removed but oil residue remains. Therefore, it is necessary
to clean the frypot before filling it with fresh oil.
NOTE: Use a LOW-FOAMING COMMERCIAL FRYER CLEANSER ONLY.
a. Turn the TEMPERATURE CONTROL THERMOSTAT (item 10) to the lowest
temperature position (fully counter-clockwise).
b. Turn the DRAIN VALVE LEVER to the CLOSED (horizontal) position and fill the
FRYPOT with 4 gallons of cold water.
c. Press the POWER SWITCH to the FRYER position.
d. When the water to come to a full boil, press the POWER SWITCH to OFF. When the
boiling ceases, slowly add, and stir-in, the LOW FOAMING COMMERCIAL FRYER
CLEANSER. Using the HIGH TEMPERATURE BRUSH supplied with the fryer, stir
until the cleanser is completely mixed with the water.
e. Press the POWER SWITCH to FRYER. When the water begins to boil, press it to
OFF. When the boiling subsides, again press the POWER SWITCH to FRYER.
Repeat this procedure (i.e. FRYER-boil-OFF) continuously for five (5) minutes.
f. Press the POWER SWITCH OFF. Allow the solution to cool to 120ºF or less.
g. Place a suitable container under the DRAIN VALVE. Turn the DRAIN VALVE LEVER to
the OPEN (vertical) position to drain the cleaning solution. Recommend draining no
more than 4” of solution at a time into the container, to prevent splashing and spilling.
Dispose of the used solution as required by local ordinances.
h. Rinse the FRYPOT with clean water. Dry with a clean non-abrasive cloth.
2. Install the LIFT CRADLE onto
the CRADLE LIFT ROD.
Note the oil level indicator.
CAUTION:BURN HAZARD / HOT WATER SPLATTER
TURN THERMOSTAT TO LOWEST TEMPERATURE SETTING
(FULLY COUNTERCLOCKWISE).
USE ONLY LOW-FOAMING COMMERCIAL FRYER CLEANER.
CAREFULLY FOLLOW CLEANSER INSTRUCTIONS AND WARNINGS.
DO NOT LEAVE FRYER UNATTENDED WHILE BOILING OUT THE KETTLE.
WHEN WATER FOAMING OCCURS, BE PREPARED TO TURN THE POWER SWITCH OFF.
Boiling water will splatter and could result in serious injury.
MAX (COLD)
MIN (HOT)
30 LB. 13KG OIL LEVEL
CRADLE PIVOT
CRADLE
LIFT ROD
CRADLE
LIFT
OIL LEVEL INDICATOR