INSTALLATION INSTRUCTIONS
5
A. UNPACKING AND INSPECTION
1. Carefully remove the FRYER from the carton. Remove all protective plastic film, packaging
materials and accessories from the FRYER and the FILTER RESERVOIR before connecting
electrical power to the FRYER or otherwise performing any installation procedures.
NOTE: DO NOT discard the CARTON and other PACKAGING MATERIAL until you have
inspected the fryer for hidden damage and tested it for PROPER OPERATION.
Refer to SHIPPING DAMAGE CLAIM PROCEDURE on the inside front cover of this manual.
2. Read all instructions in this manual carefully before starting installation of this fryer. READ
AND UNDERSTAND ALL LABELS AND DIAGRAMS ATTACHED TO THE FRYER.
3. Carefully account for all components and accessories before discarding packing materials.
Store the accessories in a convenient place for later use:
COMPONENTS
1 ea. CONDENSATE DRIP TRAY
1 ea. FILTER RESERVOIR
1 ea. FILTER SCREEN
1 ea. FILTER PAPER HOLDER
4 ea. OIL FILTER SUCTION TUBE O-RING
1 ea. BASKET
1 ea. BASKET HANDLE
ACCESSORIES
1 ea. LITERATURE PACKAGE
1 pk. FILTER PAPER
1 pk. FILTER POWDER
1 ea. HIGH TEMPERATURE BRUSH
1 ea. CLEANOUT DOWEL (WOOD ROD)
B. SERVICE TECHNICIAN INSTALLATION NOTES
1. Installation and start up should be performed by an authorized installation company.
Installer must complete the WARRANTY REGISTRATION / FRYER CHECKOUT form, and
record fryer installation particulars on the CUSTOMER SERVICE DATA form on page 19 of
this manual.
2. Verify that this FRYER installation is in compliance with the specifications listed in this manual
and with local code requirements. THIS IS THE RESPONSIBILITY OF THE INSTALLER.
3. Certain codes require fryers to be restrained with a TETHER or other RESTRAINT DEVICE.
It is the RESPONSIBILITY OF THE INSTALLER to check with the AUTHORITY HAVING
JURISDICTION, in order to ascertain the applicability of this requirement to THIS SPECIFIC
FRYER INSTALLATION.
