A SERVICE OF

logo

Open as PDF
next previous
5
1 2
3
4
5
6
Figure 3 NetCommander KVM rear panel
Rear View
Configuration (continued)
Power Socket: The power cord plugs in here from the AC power source.
On/Off Switch: Turns the KVM Switch on and off.
Firmware Upgrade Port: Plug included firmware upgrade cable into this port to down-
load firmware upgrade data.
CPU Port Section: Plug the Cat5e cables from each PC or server into these ports.
KVM Console Ports*
Integrated Console Ports*
*TheKVMcomeswithaJumperCabletoconnecttheIntegratedConsolePortstotheKVMConsolePorts.This
cablemustbeconnectedfortheunittofunction.DonotremovetheJumperCableunlessyouareinstallingaTripp
Lite B050-000 or B051-000 IP Remote Access Unit. See the IP Remote Access Unit connection
instructions on page 10 for details.
1
2
3
4
5
6
Installation
• Switchoffallcomputers*
• TheKVMcomeswithaJumperCabletoconnecttheIntegratedConsolePortsto
the KVM Console Ports. This cable must be connected for the unit to function. Do not
removetheJumperCableunlessyouareinstallingaTrippLiteB050-000orB051-000IP
Remote Access Unit. See the IP Remote Access Unit connection instructions on page 10
for details.
• Ensurethatthecablesarenotclosetoanysourcesofelectricalnoiseinterferencesuchas
fluorescentlights,HVACsystemsormotors
• EnsurethatthedistancebetweenanycomputerandtheKVMswitchdoesnotexceed100ft.
*PS/2computersneedtohavetheKeyboardandMouseconnectorsinstalledbeforetheyareturnedon.Ifyouplugthe
KeyboardandMouseconnectorsintoanactivePS/2computer,itmaynotrecognizethem,causingthemnottowork.
Pre-Installation Guidelines
Connecting the NetCommander KVM System
ConnecteachcomputertotheKVMswitchusingaTrippLiteB078-101-PS2*or
B078-101-USB*ServerInterfaceUnit(SIU)andaCat5epatchcable.
*Cat5cableshouldbenolongerthan100ft..
201002116 93-2925.indd 5 3/15/2010 11:48:41 AM