14
Rear Panel
Network Cable Connector
The Wireless Internet Camera’s rear panel features an RJ-45
connector for connections to 10Base-T Ethernet cabling or
100Base-TX Fast Ethernet cabling (which should be Category 5
twisted-pair cable). The port supports the NWay protocol,
allowing the Wireless Internet Camera to automatically detect or
negotiate the transmission speed of the network.
DC Power Connector
The DC power input connector is located on the Wireless Internet
Camera’s rear panel, and is labeled DC 5V with a single jack
socket to supply power to the Wireless Internet Camera. Power
Network Cable
Connector
DC Power
Connector
Reset Button
Antenna
Connector
10/100 Ethernet
DC 5V
Reset
ANT
15
will be generated when the power supply is connected to a wall
outlet.
Reset Button
Reset will be initiated when the reset button is pressed once, and
Power LED begins to flash.
Factory Reset will be initiated when the reset button is pressed
continuously for three seconds or when Power LED begins to
light up. Release the reset button and the Power LED will begin
to flash, indicating the Wireless Internet Camera is changing to
factory reset. When factory reset is completed, the Wireless
Internet Camera will be set to default on channel 11 and ESS-ID
is set as “NULL String” (This default setting will let the Wireless
Internet Camera connect to ANY access point on the
infrastructure network). The IP address will also return to the
default setting as 192.168.0.20.
Antenna Connector
There is one SMA type antenna connector located on the rear
panel of the Wireless Internet Camera, providing connection for
one high sensitivity antenna included in the package.
