42
System Administration – DateTime
The DateTime menu contains commands for setting the Wireless
Internet Camera's time and date requirements to provide correct
information to users who might be thousands of miles away in the
remote site. There are two options to select from the DateTime
menu bar either Synchronized with Time Server or Set Manually.
Click “DateTime” in the system administration menu bar and the
DateTime screen will appear as illustrated below:
DateTime:
Select “Synchronized with Time Server” and the time will be
based on GMT setting. The time will be synchronized every 10
minutes. This is also the default setting for the Wireless Internet
Camera.
IP Address:
Enter the IP Address of the Time Server in this field.
Click “Home” to
return to Welcome
Screen
43
Protocol:
Two options of NTP or Time are available for your selection to
link with the Time Server. The default setting is NTP.
TimeZone:
The system administrator must select the time zone for the region.
Please refer to the appendix for the time zone selection table.
To set the Date Time manually, select “Set Manually” and the
system administrator must enter the Date and Time in the
respective field manually.
Note:
When you select Set Manually, every time when the Wireless
Internet Camera is powered off and on, you must re-enter the
details once again due to time lost.
Save/Cancel:
After making sure all settings in the DateTime are correct, click
the “Save” button to store the settings for the Wireless Internet
Camera. You can alternatively click the “Cancel” button to
restore all settings to the values last saved to or retrieved from the
Wireless Internet Camera.
