46
Installation/Set up
Viewing • Listening
and Operation
Recording
Setting up
Others
■FTP by External Alarm/Motion Detection
You can control the settings to record images for FTP by External Alarm/Motion
Detection.
●
To configure the external alarm/motion detection, select “ON” in “External Alarm
Detect” or “Motion Detect” in the alarm settings (➝ page. 64)
●
To run the recording, select “Extern Alarm Detection” or “Motion Detection” in
“Connection to FTP Enable” (➝ page. 43).
1) Configure the numbers of frames you want to record for
Pre-Recording
●
Possible numbers of frames are as follows:
Enter a number in the range of 0 through 30.
2) Configure the numbers of frames you want to record for
Post-Recording
●
Enter the number between 0 and 1000.
NOTE
• Numbers of recorded image frame may decrease depending on networking
conditions and recording cycle.
3) Configure Interval(s)
●
Records 1 image per configured recording cycle (second).
Setting ranges are 1 through 10.
NOTE
• Cycle may change depending on Resolution (image size) and networking
conditions.
Recording Images on FTP Server (Cont.)
IK-WB02-37-46 2004.10.21, 02:1646
