47
Setting your terminal
TECHNICAL PARAMETERS
As delivered your fax is preset by default. However, you may adjust
it to meet your requirements by resetting the technical parameters.
To set the technical parameters:
29 OK - SETUP / TECHNICALS
+ Select the desired parameter and confirm with OK.
+ With the keys or , modify the parameter settings by
following the table below and press OK.
Parameter Setting Signification
1 - SCANNING
MODE
1 - NORMAL
2 - FINE
3 - SFINE
4 - PHOTO
Default value of the scan mode resolution for the
documents to be transmitted.
2 - TX HEADER
1 - WITH
2 - WITHOUT
If this parameter is on, your header will appear
on all documents sent to your subscribers with
your name, number, date and number of pages.
Note: In the United States, as required by
FCC regulations, a heading must be
included on all FAX messages.
3 - TX SPEED
1 - 33600
2 - 14400
3 - 12000
4 - 9600
5 - 7200
6 - 4800
7 - 2400
Transmission speed for outgoing documents.
For a quality telephone line (compatible, no
echo), communications occur at maximum
speed.
However, it may be necessary to restrict the
transmission speed for some calls.
4 - ECHO
PROTECT
1 - WITH
2 - WITHOUT
If this parameter is on, the on-line echo will be
reduced during long distance calls.
6 - EPT MODE
1 - WITH
2 - WITHOUT
For some long distance calls (satellite), the
on-line echo may disturb the call.
7 - COM.
DISPLAY
1 - SPEED
2 - PAGE
NUMBER
Choice between transmission speed displayed or
number of the page in progress.
8 - ECO ENERGY
1 - WITHOUT
2 - DELAY 5 MIN
3 - DELAY
15 MIN
4 - DELAY
30 MIN
5 - STDBY
PERIOD
Choosing the printer standby delay: the printer
will switch to standby after a delay (in minutes)
of NON-operation or during the period of time of
your choice.
