6DVD Setup Menu
53
English
3 Select
TV AspectTV Aspect
TV AspectTV Aspect
TV Aspect
• 4:3 L - Box
• 4:3 Pan Scan
•16:9 Wide
•16:9 Squeeze
Select one of the above with the cursor buttons
(5/∞) and then press the ENTER button.
Note
• The TV aspect ratios available for HDMI
outputs depend on the connected TV or
projector. For details, see the user’s manual of
your TV or projector.
• Only 16:9 Wide and 16:9 Squeeze can be
selected when the HDMI/DVI resolution is set
to 720p or 1080i.
•When this TV Aspect is in effect, it also
determines the aspect output of Composite
Video, S-Video, and Component Video.
Some monitors may use setting names that are different than those shown here.
Setup Examples
4 Select
AudioAudio
AudioAudio
Audio
• Auto: Audio is output as a bit stream
when the connected device is set to
Dolby Digital, DTS, or MPEG. Audio is
output as linear PCM when the
connected device is set to Linear PCM.
If the connected device cannot accept
bit streams, audio will be output as
linear PCM.
• PCM: Audio is converted to linear
PCM.
Select one of the above with the cursor buttons
(2/3).
Resolution
(HDMI Setting)
480p/576p
(525p/625p)
720p/1080i
(750p/1125i)
Playback Disc
Disc Recorded in Squeeze Ratio Disc Recorded in 4:3 Ratio
Aspect (HDMI Setting) Monitor Settings Aspect (HDMI Setting) Monitor Settings
Full/Squeeze
4:3
Standard
16:9 Wide 16:9 Wide
Normal
16:9 Squeeze
Normal/Through 16:9 Squeeze
4:3
Through
Note
• Audio is not output from Super Audio CDs or
DVD-Audio discs with CPPM protection.
• Audio is not output when the player is con-
nected to a device with an HDCP-compatible
DVI jack.
• All of PCM signal from digital out is converted
to 44.1kHz/48kHz.
• If DTS is played when connected equipment is
set to PCM or Audio is set to PCM, the output
of analog output from the unit is impossible.
•Turn the power on the front panel OFF during
play or pause. Noise from a television etc. may
come out.
•When the video output has been turned off
using the VIDEO ON/OFF button on the
remote control, audio cannot be output (see
page 15).
•When the video output has been set to Off in
Pure Mode and CD or Super Audio CD have
been played, audio cannot be output.
