DVD Setup Menu6
32
Using the FL menu
The FL menu has been designed to set
“HDMI ON/OFF”, “HDMI RESET” and
“REMOT CODE”.
The FL menu cannot be used if a disc is
playing.
It is recommended to set the FL menu
before loading a DVD.
If a DVD has been loaded, be sure to press
7 (STOP) twice before proceeding.
(If “RESUME” is displayed in the FL display,
press 7 (STOP).)
Selecting the FL menu
Press SET UP for longer than 2 sec.
The FL OFF indicator on the player turns on and
off.
FL menu is displayed in the FL display.
Use the cursor buttons (5/∞) to select the FL
menu you want as follows.
(Example)
To exit the FL menu
When you have compleated setting up the FL menu
or if you want to exit the FL menu, press SET UP
to close the FL menu.
Press ENTER you want to set.
The menu selection is set.
Note
If you want to use HDMI function, set the HDMI in
the SETUP menu. (page 52)
HDMI RESET
Select HDMI RESET, then press ENTER.
"SURE" is displayed in the FL menu.
Press ENTER if you want to RESET.
The menu selection is set.
Note
If images are not displayed properly on the TV or
projector after making HDMI setting on the Setup
menu, reset the set (see page 54).
This will return the HDMI setting to the state
before the setting was made.
HDMI ON/OFF setting
Select HDMI ON/OFF, then press ENTER.
Use the cursor buttons (5/∞) to select ON or
OFF as follows.
(Example)
HDMI ON/OFF
HDMI RESET
REMOT CODE
SET UP
MENU
STOP
Press ENTER you want to set.
The menu select is set.
• The DVD player support two remote control
codes: DVD 1 and DVD 2.
•Set the remote control code of the Remote
Control to the same setting.
• See page 15 for more information.
REMOT CODE setting
Select REMOT CODE, then press ENTER.
Use the cursor buttons (5/∞) down to select the
type of REMOT CODE you want to set as follows.
(Example)
FL OFF
HDMI/DVI
STANDBY
POWER
PAUSEPLAY
OPEN/CLOSE
STOP
ON/OFF
LEVEL
+
PHONES
-
FL OFF
FL menu
HDMI ON
HDMI OFF
* Factory setting
*
DVD 1
DVD 2
* Factory setting
*
