Using the Operator Panel
2-68 ADVANCED OPERATION GUIDE
the orientation of the printed page. You can use long-edge or short-edge
binding with either landscape or portrait printing.
Depending on the binding type and print orientation, the duplexer provides
four types of binding. These are: (1) portrait, long-edge, (2) portrait, short
edge, (3) landscape, long-edge, and (4) landscape, short-edge. The figure
below shows these binding methods.
This procedure can only be performed when the optional duplexer is
installed.
1
Press [MENU].
2
Press U or V repeatedly until Paper
Handling > appears.
3
Press Z.
4
Press U or V repeatedly until >Duplex
Mode appears.
5
To activate duplex printing, press [OK]
([ENTER]). A blinking question mark (?)
appears.
6
Press U or V to display the desired binding mode. The message display
toggles through the following:
None (default)
Short edge bind
Long edge bind
7
When the desired binding mode is displayed, press [OK] ([ENTER]). The
binding mode is set.
8
To exit the menu selection, press [MENU].
(1)
(3)
(2)
(4)
Portrait,
long-edge
Landscape,
long-edge
Portrait,
short-edge
Landscape,
short-edge
Paper Handling >
>Duplex Mode
None
>Duplex Mode
?None
