Using the Operator Panel
2-80 ADVANCED OPERATION GUIDE
5
To change the timeout time, press [OK]
([ENTER]). A blinking cursor (_) appears.
6
Press U or V to increase or decrease the value at the blinking cursor and
set the desired time. The timer can be set between 5 and 240 min, in 5-
minute increments. Use Z and Y to move the cursor right and left.
7
When the desired timeout time is displayed, press [OK] ([ENTER]).
8
To exit the menu selection, press [MENU].
Received Data Dump
You can print data received by the printer as hexadecimal code for
debugging programs and files.
1
Press [MENU].
2
Press U or V repeatedly until Others >
appears.
3
Press Z.
4
Press U or V repeatedly until >Print
HEX-DUMP appears.
5
Press [OK] ([ENTER]). A question mark (?)
appears.
6
Press [OK] ([ENTER]) again. The message
Processing appears for a second,
followed by Waiting.
7
While the message display is indicating Waiting (for 30 seconds by
default), send data to be hex-dumped to the printer. The message display
indicates Processing while the data is being received.
You can cancel printing of any more dump data by pressing [GO] and then
[CANCEL].
>Sleep Timer
005
min.
Others >
>Print HEX-DUMP
>Print HEX-DUMP?
Processing
Waiting
