Remote Set &
Resume Switch
2092042 - Cab Controls with
Accelerator Pedal
2092045 - Cab Controls without
Accelerator Pedal
2092043 - Remote Station with
Remote Throttle
2092044 - Remote Station without
Remote Throttle
For applications where PTO Mode controls are located inside the cab and the
accelerator pedal is to remain active, use Cab Controls with Accelerator Pedal
(Example: Dump Truck).
For applications where cab controls will be used to control the engine speed in PTO
Mode and the accelerator is required to be disabled, use Cab Controls without
Accelerator Pedal (Example: Tanker).
For applications with a remote PTO Mode control station using switches while also
requiring full range throttle control, use Remote Station with Remote Throttle
(Example: Mobile Crane). It is recommended that when remote throttle controls will
be used, remote PTO and throttle provisions be added.
For applications with a remote PTO Mode control station using only switches to
control engine speed in PTO Mode, use Remote Station without Remote Throttle
(Example: Vacuum Truck). It is recommended that when remote controls will be
used, remote PTO provisions be added.
Feature Options
1 Programmable Preset Engine Speeds in Remote PTO Mode
2 Programmable Preset Engine Speeds in Remote PTO Mode
When Remote PTO Engine Speed Control is configured with one preprogrammed
preset speed, pressing Remote Set momentarily after entering PTO mode will cause
the engine speed to increase to PTO Remote Preset Speed #1 (N055). This
functionality is not time dependent, and PTO Remote Preset Speed #1 (N055) can
be triggered at any time after entering PTO mode as long as Remote Set is
momentarily pressed before any other switch. After pressing Remote Set, or if any
