1) Tap the RemoteLinc 2 switch (top or bottom paddle) - if in 2 scene mode, tap the top of the paddle for
scene 1 or the bottom for scene 2
The responder will respond
2) Press & hold the RemoteLinc 2’s Set button until it beeps
RemoteLinc 2’s LED will blink GREEN
3) Press & hold the RemoteLinc 2’s Set button until it beeps again
RemoteLinc 2’s LED will blink RED
4) Press & hold the Responder’s Set button until it double-beeps (or LED blinks)
RemoteLinc 2 will (Beep)-(Beep) and its LED will stop blinking
5) Confirm that Unlinking was successful by tapping on/off on your RemoteLinc 2
The responder will not
respond
6) If you wish to remove multiple responders from RemoteLinc 2, repeat steps 1-5 for each additional
responder (or see Remove Multiple Responders from a Scene
)
Using RemoteLinc 2
1 Scene Mode (Default)
The switch controls scene members as follows:
Paddle Tap Press & hold Double-tap
Top
Turn scene on
Brighten scene members
until released
Turn scene members full-
bright instantly
Bottom
Turn scene off
Dim scene members
until released
Turn scene members off
instantly
2 Scene Toggle Mode
The top and bottom paddle will control all its scene members as follows:
Last Command Sent Tap Press & hold Double-tap
Off or Dim
Turn scene on
Brighten scene
members until
released
Turn scene
members full-bright
instantly
On or Bright
Turn scene off
Dim scene members
until released
Turn scene
members off
instantly
2 Scene Non-Toggle Mode (Always On)
Each button will control all its scene members as follows:
Tap Press & hold Double-tap
Turn scene On
Brighten scene members until
released
Turn scene members full-
bright instantly
Note: Devices in scenes that respond to the scene trigger by turning off do not respond to scene dims
and brights. Devices in Scenes that only support On/Off (such as switches and relays) do not respond to
scene dims and brights.
Page 7 of 15 2444A3 Rev: 10/24/2011 10:43 AM
