Beeper Yes, configurable
Battery Charging LED Yes, Embedded (shines red through case during charge)
RF Range 50’ Line-of-Sight
Retains all settings without power Yes, all saved in Non-volatile EEPROM
Mechanical
Color White
Plastic UV Stabilized ABS
Button Configurations 1 Scene (standard), 2 Scene (optional button kit)
Dimensions 2.6" H x 1.3" W x 0.39" D
Weight (w/battery) 1 Oz.
Button Style Plastic Paddles over Contact Switches
Wall Mount
Tabletop Stand
Optional Hardware
Visor Clip
Operating Environment Indoors, 32°F to 104°F, up to 85% relative humidity
Electrical
Battery type 3.7 VDC Lithium Polymer, Rechargeable, non-replaceable
Battery life (between charges) > 3 months under standard usage
Battery Re-charging cycles > 500 recharging cycles
Recharging jack Standard, Micro-USB, 5VDC
Recharging time ~1 hour
Sends Low Battery Warning Yes
Troubleshooting
Problem Possible Cause Solution
RemoteLinc 2 may be out of range of
nearest dual-band INSTEON device
(hopper)
Try moving an access point or other dual-band
plug-in module closer to RemoteLinc 2
The INSTEON signal may not be
getting to the “vicinity” of responder
Make sure phases are bridged, add additional
INSTEON devices and/or move around existing
INSTEON devices
Large appliances, such as refrigerators
or air conditioners, may be producing
electrical noise on the power line
RemoteLinc 2 won’t add a
scene responder
Other electrical devices, such as
computers, televisions, or power strips,
may be absorbing the INSTEON signal
Install a power line noise filter (e.g. #1626-10) to
filter electrical noise and minimize signal attenuation
RemoteLinc 2 will not turn
a Responder On (it may
turn it off)
Ramp Rate may be Extremely Slow
Or
Responder may be Linked at OFF
Re-link to responder with fast Ramp Rate
Page 13 of 15 2444A3 Rev: 10/24/2011 10:43 AM
