15
Factory Reset SmartLinc
1. Unlink all devices from SmartLinc. If you do not remove all links, the previously-linked responders
will retry communications and cause network delays. See Removing SmartLinc as an INSTEON
Controller for instructions.
2. Unplug SmartLinc and wait about 10 seconds.
3. Press and hold SmartLinc’s Set button. While holding in Set button, plug SmartLinc back in.
SmartLinc will begin to emit a long beep.
4. When beep stops, release Set button. The Status LED will turn off, then turn back on solid.
Resetting SmartLinc to its factory default settings will clear all of its internal memory. All links, room/
scene names, timers, camera URLs and check boxes will be erased and reset; DHCP will be
enabled; the port number will be reset to 80; and SmartLinc authentication will be disabled.
Using Custom Commands in SmartLinc
1. Navigate to the command line of the scene
you want to control and note the On and Off
scene strings and scene number (displayed
below the command line).
2. Navigate to the command line of the scene
to which you want to add another scene’s
control.
3. To add another scene’s control to the current
scene, enter either the On or Off scene string
you noted in step 1 into its command line.
Example command: 0261011101
Scenecommandsareaneasy,efcientwayto“copy”SmartLincscenes.
INSTEON Scene Commands
An INSTEON scene string breaks down like this:
1. 0261: starts INSTEON scene string
2. 01: scene number of the scene to control
3. 11: corresponds to INSTEON On command
4. 01: scene number
You can change any part of the scene string to send different commands to different scenes. Use the
INSTEONtranslationtableonthenextpagetondcorrespondingcodes.
