A SERVICE OF

logo

Open as PDF
next previous
Chapter 5 SCO Setup
164
5. Change to the
dest
directory.
Syntax:
cd dest
6. List the contents of this directory using the dir command and
determine which destination/queue you would like to send the
print job through. Most likely, you will select d1prn for the PRN
port.
7. Change to this destination directory.
Example:
cd d1prn
8. Change the mode to correspond with the type of file you are
going to print. By default, ASCII is set for text-only files, but if
you need to print both text and graphics, select binary using the
bin command.
9. Place the file to be printed within this directory on the Ethernet
Interface, so it can be spooled and printed.
Syntax:
put filename
10. Close the FTP session, unless you have more jobs to print.
Syntax:
quit