Hewlett-Packard 8591C Manual

A SERVICE OF

next previous

I

-

I

-

Using Spectrum Analyzer Features

learn How to Enter Amplitude Correction Factors

NOTE

After pressing PURGE AMP COR the first time, the message If you are sure, press

key again to purge data will appear. Pressing PURGE AMP COR a second time

erases the amplitude-correction data.

6. Specify the first amplitude-correction point by pressing the following

keys:

SELECT FREQ

50

IhllHz)

8

f$SX--

7. Specify the second amplitude-correction point by pressing the following

keys :

Table entries can be edited if you make a mistake. To edit an existing point, use

SELECT POINT to specify the point. Then use SELECT FREQ or

SELECT AMPLITUD to specify the entry that you wish to edit.

8. Specify the third and fourth amplitude-correction points by using the

following key sequence:

300@

11

[WI

350

INIHz)

18

[+dBmV)

3-59

-