Microplate Luminometer System Description
15
2.3 Injector Unit (optional)
The MONOLIGHT 3096 injector unit consists of two highly pre-
cise Cavro pumps and the control unit which is integrated in the
housing.
The injector unit is programmed such that the left pump is con-
nected to the left injector tip in the MONOLIGHT 3096. In the
Simplicity PC software the left injector is Injector 1.
Microplate Injector head Injector Injector unit
loading area tubings
The right pump is connected to the right injector tip in the
MONOLIGHT 3096. In the Simplicity PC software, the right
injector is injector 2. The injector unit is closed by a plastic
cover on the front which can be taken off to connect the tubing
and to service the injector unit (see section 8). Lift the cover up
vertically from above.
Pass the injector tubings left to the MONOLIGHT 3096 and up to
the reagent bottles which are placed on the tray onto the front
side of the injector unit. Pass the tubings through the respective
openings and make sure you don’t damage or squeeze them
(see Figure 2-8).
Figure 2-8:
MONOLIGHT 3096
with connected
injector unit (both
devices open)
Injector 1
Tray for reagent bottles
Injector 2
