9
Operating Sequence
Before the first wash we recommend that you pour 2
litres of water into the main wash compartment of
the detergent drawer in order to activate the ECO valve.
Then run a cotton cycle at 95°C, with the machine
empty, in order to remove any manufacturing residue
from the drum and tub.
Pour half a measure of detergent into the main wash
compartment and start up the machine.
1.Load the laundry
Open the door.
Place the laundry in the drum, one item at a time,
shaking them out as much as possible.
Close the door.
2.Measure out the detergent
Pull out the dispenser drawer until it stops. Measure out
the amount of detergent required and pour it into the
main wash compartment .
If you wish to carry out the prewash, pour detergent into
the appropriate compartment marked .
3.Measure out the fabric
softener
If required, pour fabric softener into the compartment
marked , without exceeding the «MAX» mark.
Close the drawer gently.
C0065
C0064
P0004
4.Switch the machine on
Press the ON/OFF button to switch the machine on: the
light above the button will light up.
5. Select the desired programme/
fabric
Press the FABRICS button repeatedly, in order to select
the desired programme/fabric. The relevant light will
light up.
The lights relevant to the phases that form the
programme will light up.
The “Start/Pause” button light will start flashing.
6. Select the temperature
Press the “Temp.” button if you wish to select a
temperature value different from the one proposed by
the washing machine.
The relevant light will light up.
60°C
50°C
95°C
40°C
30°C
Temp.
Prewash
Wash
Rinse
Rinse Hold
Spin
Drain
Filter
End
Delicates
Wool
Cottons
Synthetics
O
N
/
O
F
F