Filter
Top Products
7
• Drain and Spin:
- Choose the previously selected programme by means
of the FABRICS button, afterwards change the spin
speed if needed, by means of the “Spin” button and
then press “Skip/Reset” button twice until the ‘Spin”
light illuminates and then depress
“Start/Pause”
button.
6 OPTIONS button
Press this button to select the following options:
● Prewash: select this option if you wish your laundry
to be prewashed before the main wash (not available
for wool).
The prewash ends with a short spin in programmes
for cotton and synthetic fabrics, whereas in the
programme for delicate fabrics the water is only
drained.
● Extra Quick: select this option for laundry that is
only slightly soiled (not for Wool programme).
The washing time will be reduced according to the
type of fabric and the selected temperature.
● 40° AA: this option can be selected for cottons and
synthetics lightly or normally soiled with a
temperature of 40°C or higher.
If you select 40°C together with option 40° AA, the
machine will prolong the time at 40°C in the washing
phase. On cotton programme this will allow an AA
class in energy efficiency and washing performance to
be achieved.
If you select 95°C, 60°C or 50°C and press the
40° AA button, the washing temperature will be
reduced and the washing time will be prolonged.
The Prewash, the Extra Quick and the 40° AA options
cannot be selected together by means of the relevant
button.
7 “Start/Pause” button
This button has two functions:
• Start: after you have selected the desired programme
and options, press this button to start the washing
machine. The light above the button will stop flashing
and remain lit.
• Pause: when you press this button again, the
programme in progress is interrupted. The light above
the button will start flashing. To restart the
programme, press the button again.
Important! You must set the washing machine to
Pause before you make any change in the programme
in progress.
8 “Skip/Reset” button
At the end of a programme, you must press this button
once or repeatedly, in order to clear the contents of the
memory; otherwise, the next time you switch the
washing machine on, the audible warning signals
relevant to the end of the previous cycle will be given.
You can also press the “Skip/Reset” button to exclude
one or several phases of the programme which is
running, as indicated below.
- set the washing machine to Pause by pressing the
“Start/Pause” button (the relevant light will flash);
- press the “Skip/Reset” button once or several times, until
the required phase(s) is(are) cancelled (the light next to
the symbol of the phase(s) will go out).
Example:
In this case, the spin (at
the speed provided for
the selected type of
fabric) will be
performed.
This button allows you also to select special
programmes, such as Rinse, Spin and Drain.
• If the machine is already switched on because it has
just performed a washing programme, proceed as
follows:
- depress “Skip/Reset” button once or repeatedly to
cancel the previously performed programme (all the
phase indicator lights must be off);
- select the type of fabric by means of the relevant
button;
- select the special programme:
• Rinse and Spin
Depress “Skip/Reset” once, the “Wash” pilot light
goes out.
• Spin
Depress “Skip/Reset” twice, the pilot lights “Wash”
and “Rinse” go out.
Prewash
Wash
Rinse
Rinse Hold
Spin
Drain
Filter
End