Filter
Top Products
10
7. Select the spin speed or the
RINSE HOLD option
Press the “Spin” button repeatedly, in order to select the
desired spin speed or the Rinse Hold option. The
relevant light will light up.
If you select the Rinse Hold option, the machine will
stop at the end of the programme with the water still in
the tub.
ZWX 1605 W ZWX 1505 W
8. Select the desired options
If your laundry is very dirty, it may be advisable to
select the Prewash option.
If your laundry is only slightly soiled, select the Extra
Quick option
If your laundry is lightly or normally soiled and it is
necessary to prolong the washing time, select the
40° AA option.
9. Start the programme
Press the “Start/Pause” button. The relevant light will
stop flashing and only the light relevant to the phase that
is in progress will remain lit.
Start/
Pause
Prewash
Extra
Quick
40° AA
Spin
1500
900
700
500
Rinse Hold
Spin
1600
900
700
500
Rinse Hold
10. How to change an option or
a programme during its cycle
Before you make any change, you must pause the
washing machine by pressing the “Start/Pause” button.
It is possible to change any option or temperature before
the programme carries it out.
Changing the type of fabric is possible, obviously, only
during the washing phase and after you have cancelled
the running programme by means of the “Skip/Reset”
button. When you make a change in this parameter, the
washing machine will resume the cycle from the
beginning maintening the water in the drum.
If it is necessary to drain the water in order to change
the programme in progress, proceed as follows:
• Pause the machine by pressing the “Start/Pause”
button;
• press the “Skip/Reset” button repeatedly, until only
the “Drain” light remains lit;
• press the “Start/Pause” button again.
You may now select a new programme and press the
“Start/Pause” button to start it.
11. How to cancel a programme
during its cycle
To cancel a programme that is being carried out, first
pause the washing machine by pressing the
“Start/Pause” button, then press the “Skip/Reset” button
repeatedly, until the phase indicator lights go out.
12. How to open the door during
the cycle of a programme
You can open the door, after having set the washing
machine to PAUSE, provided the following conditions
exist:
• the washing machine is not in the heating phase
beyond 55°C;
• the level of the water is not high;
• the drum is not turning.
If these requirements are met, when you pause the
washing machine, the door can be opened.
Should it not be possible to open the door, and should it
be absolutely necessary to do so, switch the machine off
by pressing the “On/Off” button.
After approximately 3 minutes, you can open the door.