Filter
Top Products
Cleaning the water inlet filters
Important! If the appliance doesn't fill, it takes a long time
to fill with water, the starting button flashes red or the
display (if available) shows the relevant alarm (see
chapter "What to do if..." for more details), check if the
water inlet filters are blocked .
To clean the water inlet filters:
• Turn off the water tap.
• Unscrew the hose from
the tap.
• Clean the filter in the
hose with a stiff brush.
• Screw the hose back onto the tap. Make sure the
connection is tight.
• Unscrew the hose from
the appliance. Keep a
towel nearby because
some water may flow.
• Clean the filter in the
valve with a stiff brush
or with the piece of
cloth.
• Screw the hose back to the appliance and make sure
the connection is tight.
• Turn on the water tap.
What to do if…
The appliance does not start or stops during operation.
Certain problems are due to lack of simple maintenance
or oversights, which can be solved with the help of the
indications described in the charts, without calling out an
engineer.
During appliance operation it is possible that the red pilot
light of the button 9 flashes, the display shows a fault code
and the buzzer sounds to indicate that the appliance is not
working.
Before contacting your local Service Centre, please carry
out the checks listed below.
Fault code and malfunction Possible cause / Solution
Problem with the water supply
The water tap is closed.
• Open the water tap.
The inlet hose is squashed or kinked.
• Check the inlet hose connection.
The filter in the inlet hose or the inlet valve filter are blocked.
• Clean the water inlet filters (read "Cleaning the water inlet filters" for more details).
24