Filter
Top Products
7
4 OPTION buttons
Depending on the programme, different functions can be
combined. These must be selected after choosing the
desired programme and before depressing the
START/PAUSE button.
When these buttons are pressed, the corresponding pilot
lights come on. When they are pressed again, the pilot
lights go out.
If an incorrect option is selected, the pilot lights flash for
about 2 seconds and the message Err is displayed.
Press these buttons to select the following options:
• PREWASH: select this option if you wish your laundry
to be prewashed before the main wash (not available
for wool and handwash cycle, miniprogram and silk).
The Prewash ends with a short spin at 650 rpm in
programmes for cotton and synthetic fabrics, whereas
in the programme for delicate fabrics the water is only
drained.
• EXTRA QUICK: this option can be used for lightly
soiled (not for wool, hand wash, silk and
miniprogramme) in order to obtain a good washing
programme in a short time. The washing time will be
reduced according to the type of fabric and the selected
temperature.
“Extra Quick” cannot be used with E-Cottons, 40°
AA, E-Synthetics programmes.
• SUPER RINSE: this option can be selected with all
programmes, except the wool programme and
handwash. The machine will add 2 rinses for cottons
and 1 rinse for synthetics, delicates and silk.
This option is recommended for people who are allergic
to detergents, and in areas where the water is very soft.
• EASY IRON: selecting this button the laundry is
gently washed and spun to avoid any creasing. In this
way ironing is easier. Furthermore the machine will
perform 6 rinses instead of 3 for cotton and 4 rinses
instead of 3 for synthetics. This function can be used
for cotton and synthetic fabrics.
If this option is selected for cotton programmes, the
spin speed automaticaly will reduce to 900 rpm.
If this option is selected for synthetic programmes
with a temperature of 60°C or 50°C, the machine will
perform a washing cycle at max 40°C.
5 DELAY START button
The wash programme can be delayed from 30 min - 60
min - 90 min, 2 hours and then by 1 hour up to a
maximum of 23 hours by means of this button.
Selecting the delayed start
• Select the programme and the required options.
• Select the delay start.
• Depress START/PAUSE button: the machine starts its
hourly countdown.
The programme will start after the selected delay has
expired.
DELAY START cannot be used with “Drain”, “Spin” or
“Delicate spin”
.
Cancelling the delayed start
• Depress START/PAUSE button.
• Depress DELAY START button until “0’”is
displayed.
• Depress START/PAUSE button again.
6 DISPLAY
The display shows the following information:
Duration of the programme - Delayed start -
Incorrect option selection - Alarm code - End of
programme.
After selecting a programme, the duration is displayed
in hours and minutes ( for example 2.05).
The duration is calculated automatically on the basis of the
maximum recommended load for each type of fabric.
After the programme has started, the time remaining is
updated every minute.
Duration of the selected programme