Zanussi ZWF 1640 W Washer User Manual


 
1212
13. How to cancel a programme
during its cycle
Turn the selector dial to O to cancel a programme
which is running. Now you can select a new
programme. The water in the drum will be not emptied
out.
14. How to open the door during
the cycle of a programme
First set the machine to PAUSE by pressing the
START/PAUSE button.
If the door does not open, this means that the machine is
already heating, that the water level is above the bottom
edge of the door or that the drum is turning.
If you cannot open the door but you need to open it you
have to switch the machine off turning the selector dial
to O . After about 3 minutes the door can be opened
(pay attention to the water level and temperature!). To
restart the programme switch on the machine and select
again the desired programme and options.
15. End of programme
The washing machine stops automatically.
If the Rinse hold option has been selected, the light
of the START/PAUSE button goes off, the light and
the “End” pilot light remain lit to indicate that the water
must be drained before opening the door. The display
shows a flashing zero.
To empty out the water you can select programme
“Drain”, the water is emptied out without spinning or
select programme “Spin” or “Delicate Spin”. Select the
spin speed by means of the relevant button and then
depress the START/PAUSE button. The water is emptied
out and the laundry is spun at the selected spin speed.
Turn the programme selector dial to Reset O to switch
the machine off.
Remove the laundry from the washing machine.
Check whether the drum is completely empty, by
rotating it with your hand. The purpose of this is to
prevent any items of laundry from remaining
accidentally in the drum, where they might get damaged
in a subsequent wash (e.g. by shrinking) or bleed colour
into another load of laundry.
We advise you to close the water supply tap and
disconnect the plug from the socket.
Leave the door ajar in order to air the washing machine.