Filter
Top Products
Accurate levelling prevents vibration, noise and dis-
placement of the appliance during operation.
Repeat the levelling action, if the appliance is not level
and stable.
Water inlet
Connect the hose to a tap
with a 3/4” thread.
35°
45°
Loosen the ring nut to angle the hose to the left or right
depending on the position of your water tap. Do not
place the inlet hose downwards. After positioning the
inlet hose, be sure to tighten the ring nut again to pre-
vent leaks.
Water drainage
Firstly form a hook in the end of the drain hose using
the plastic hose guide supplied with the appliance .
The end of the drain hose can be positioned in three
ways:
• Hooked over the edge of a sink using the plastic hose
guide.
Tie the plastic hose guide to the tap with a string to
prevent that the drain hose unhooks when the appliance
is emptying.
• Onto a sink outlet spigot.
Push the drain hose onto the spigot and secure with a
clip, ensure a loop is formed in the drain hose to prevent
waste from the sink entering the appliance.
If the outlet spigot has not been used before, remove
any blanking plug that may be in place.
• Directly into a drain pipe at a height of not less than
60 cm and not more than 100 cm.
MAX 100cm
The end of the drain hose
must always be ventilated ,
i.e. the inside diameter of
the drain pipe must be
larger than the outside di-
ameter of the drain hose.
The drain hose must not
be kinked.
• Directly to a built-in drain pipe in the room wall.
8