Filter
Top Products
5
Delay Start
3H
6H
9H
The start of the programme can be delayed by 9, 6 or 3 hours by means of
this button. The relevant light illuminates.
You must select this option after you have set the programme and before
you start the programme.
Select a delayed start:
• select the programme and the required options;
• select the delay start by pressing the button 5 ;
• press the button 6 :
– the appliance starts its hourly countdown.
– The programme will start after the selected delay has expired.
Cancelling the delayed start after having started the programme:
• set the appliance to PAUSE by pressing the button 6 ;
• press the button 5 once, the light relevant to the selected delay goes off;
• press the button 6 again to start the programme.
The DELAY START cannot be selected with the drain programme.
Important! The selected delay can be changed only after selecting the
washing programme again. The door will be locked throughout the delay
time. If you need to open the door, you must set the appliance to PAUSE
(by pressing the button 6 ) and then wait a few minutes. After you have
closed the door, press the button 6 again.
6
Start/Pause
Start the programme by pressing the button 6
• To start the selected programme, press the button 6 , the corresponding
green pilot light stops flashing. The pilot light 7.1 illuminates to indicate
that the appliance starts operating and the door is locked. If you have
chosen a delayed start, the appliance will begin the countdown.
• To interrupt a programme which is running, press the button 6 : the
corresponding green pilot light starts flashing. It is possible to
change some options of a running programme before the programme
carries them out.
• To restart the programme from the point at which it was interrupted,
press the button 6 .
• After the programme has started the door is locked. If, for any reason,
you need to open the door , set firstly the appliance to PAUSE by pressing
the button 6 . After a few minutes it will be possible to open the door.
If the door remains locked, this means that the appliance is already
heating or that the water level is too high. In any case, do not try to force
the door!
If you cannot open the door but you need to open it you have to switch
the appliance off by turning the selector dial to
. After a few minutes
the door can be opened ( pay attention to the water level and tempera-
ture! ). After closing the door, it is necessary to select the programme
and options again and to press the button 6 .
15