Filter
Top Products
Solving laundering problems
Most laundering problems are easily solved if you understand the cause. Check the following list
for problems you may have and possible causes. If you need additional help, check the ‘Assis-
tance or Service” section of this book.
PROBLEM
1 CAUSE
Brown, yellow
1 l Chlorine staining
stains
Dye transfer
l Iron in water heater or pipes
l Iron and manganese in water
l Improper sorting
l Load not immediately removed from washer after end of cycle
Gray whites,
dingy colors
l Improper sorting
l Water temperature too low
l Not enough detergent
. Using soap in very hard water (use detergent if you have hard water)
l Undiluted fabric softener or fabric softener poured directly on load
l Fabric softener in wash water
l Not enough detergent
Greasy looking
spots
Lint
Load too wet
after spin
l Improper sorting
l Paper or tissue in pockets
l Pilling being mistaken for lint
l Overloading
l Not enough detergent
l Clogged lint filter
l Cold rinses
l Lid is opened before spinning is completed
Shrinking
l Fabric type (some knits stretch during manufacturin@aundering returns
fabric to original size)
l Care label directions not followed
Snags, rips, holes
l Items damaged before washing
l Misuse of chlorine bleach
l Sharp articles not removed from pockets
l Overloading
l Fasteners not fastened
Stiff, rough fabrics
l Using soap in very hard water (use detergent if you have hard water)
(usually cottons)
l Not enough detergent
l Line drying
Twisting, tangling
l Overloading
l Improper loading (do not wrap large items around agitator)
Wrinkling
l Overloading
l Load not immediately removed from washer after end of cycle
l Improper rinse temperature
l Cycle selection is incorrect (based on fabric type)
Yellow areas
(from body oils)
l Water temperature too low
l Not enough detergent
19