Filter
Top Products
Other operating instructions
,:&@j J
N-3,
,- :,‘,
$L; ‘;(g
For
a rinse and spin
For a
drain and spin
You may need an extra rinse
Your washer can be set to drain
and spin for heavily soiled loads and spin out water.
which need more detergent. [Extra
l
Push Control Knob in.
detergent can require an extra rinse.)
l
Turn clockwise to the bar just before
l
Push Control Knob in.
l
Turn clockwise to any
l
on the dial.
See above drawing.
l
Pull control Knob out.
l
The washer will fill, agitate, drain
and spin.
OFF in any cycle. See above
drawing.
l
Pull Control Knob out
9 The washer will drain and spin.
For agitation and spin speeds in each cycle, see pages 8-11.
For a soak or pre-wash
For best results, use warm water
for soaking or pre-washing stained
laundry. Hot water can set stains.
l
Use recommended amount of
detergent or pre-soak product.
* Push Control Knob in.
l
Turn clockwise to point at a number
In the SOAK Cycle...use the 2-
minute mark for a pre-wash.
l
Pull Control Knob out to start washer
l
When the. cycle is over, add de-
tergent for the next selected wash
cycle. The SOAK Cycle should
Important: See additional care
/f@& fL.t;;;;;;;;L”:::
l
Set the washer and start the next
‘To start soak or pre-wash with agitation, the Cycle Control Knob
must point to a number in the SOAK Cycle.
Cleaning the lint filter
Clean filter after every load for best
filtering results. Note: The load type
will vary the amount of lint build-up.
To clean:
l
Lift off the agitator barrel.
l
Wash or wipe the filter clean in the
bottom of the agitator barrel. The
filter is not removable.
l
Replace the agitator barrel and
snap into place
12