Filter
Top Products
Using Your Washer
-zYeize
Whirlpool
ZSPEED ZCYCLE
Your automatic washer
IS easy to
use.
To make it even easier, read the
following steps before starting your first
load.
Start your washer after you put in
detergent, the loud, and any other
laundry aids according to Information
on page 3.
1.
Select a cycle and start the
washer.
l
Push the Cycle Control Knob in and
turn it to the right [clockwise]
l
Stop when the pointer is on the num-
ber of minutes you want in the cycle you
want.
l
Instructions for which cycles to use for
each fabric type are under the lid.
l
To start the washer, pull the Cycle
Control Knob out. When the cycle IS
over, the washer WIII stop.
l
To stop the washer at any time.
during a cycle, push the Control
Knob in.
Pull it out to restart the washer
l
To change Q setting,
push the Con-
trol Knob in to stop the washer Then
turn the Control Knob to the right (clock-
wise] to the setting you want. Pull the
knob out to start the washer
2. To adjust the wash water
temperature. )
l
Hot wash
can be selected only in the
REGULAR HEAVY Cycle Push in and
turn the Cycle Control Knob so the
pointer is on from 10 to14 minutes in the
REGULAR HEAVY Cycle Pull the Control
Knob out to start.
l
Warm wash
can
be selected in the
REGULAR HEAVY Cycle Push in and turn
the Cycle Control Knob so the pointer is
on from 7 to 9 minutes. Pull the Control
Knob out to start
4