Whirlpool LB3000XK Washer/Dryer User Manual


 
loading your
Washer
---
Understanding
Your Washer
For best washing results and
energy savings, sort the laundry
carefully.
1. Sort the Laundry into loads.
l
Group the laundry into loads that
can be washed and dried together.
See the Laundry Guide for informa-
tion and samples of typical loads.
l
Try to mix large and small items for
best movement in the washer.
2. Measure Detergent; Add to
Washer Basket.
l
See detergent information on page
6 and in Section IV of the Laundry
Guide.
l
Add dry bleach or water condi-
tioner (not fabric softener) if used.
Follow the package directions
carefully.
3. Dilute liquid Bleach Before Add-
Ing to the Washer Basket.
l
See the “Laundry Aids” section of
the Laundry Guide for more
information.
4. load the Washer.
l
Spread the load evenly. [Don’t put
all the towels on one side and a few
wash cloths on the other.) An unbal-
anced load can cause the washer to
shake during spinning.
l
Load without packing so items can
move freely for best cleaning and
least wrinkling.
5. Add Diluted Fabric Softener Only
to the Deep Rinse Cycle.
. DO NOT ADD FABRIC SOFTENER TO
THE WASH. Fabric softeners can com-
bine with soap or detergent to make
greasy stains on fabrics.
This automatic washer has cycle
jettlngs with different agltatlon and spin
speeds for different fabric types For
example, the REGULAR HEAVY Cycle
70s high agitation and spin speeds;
<NIT GENTLE has low agltatlon and
spin speeds
You can control the wash water
‘emperature and the amount that fills
the washer by moving the control dial
according to instructions on page 4
Sections
in
this Use & Care Guide
go into detail on the “what and why”
of each setting Read this and the Laun-
l-iry Guide carefully to get the best
,zleaning results.
Cleaning the Lint
Filter
Water runs through the lint filter
whenever the washer agitates. Check it
often to make sure it’s clean
and filter-
Ing at its best
To remove it for cleaning, press
the release and pull straight out. lnstruc-
tions for cleaning are printed on the
bottom of the filter