Liquid bleach dispenser
Always measure bleach. Do not
guess. Never use more than 1 cup
(250 ml) for a full load. Use less with
lower water level settings. Follow
directions on bottle for safe use. Use
a cup with a pouring spout to avoid
spilling.
1. Load the washer first
2. Pour measured bleach carefully
into dispenser. DO NOT let bleach
splash, drip or run down into the
washer basket. Undiluted bleach
will damage any fabric if touches.
3. Start the washer. Bleach will be
diluted automatically during the
wash part of the cycle.
For more information on bleaching, see “Laundry Guide” page 11.
MAGIC CLEAN@ lint filter
The lint filter in your washer cleans
itselt. Collected lint is drained away
with the wash and rinse water.
If your washer drains into a tub,
remove any lint collected in the drain
or strainer.
Liquid fabric softener dispenser
1.
Add liquid fabric softener to the
dispenser using the amount rec-
ommended on the bottle. (Avoid
dripping or spilling any fabric
softener on the load.]
2. IMPORTANT: Always add wafer
(Y2 to1 cup) to dilute fabric softener
to the FULL mark on the dispenser.
3. Diluted fabric softener will be
added to the load when the
washer stops spinning after the wash part of the cycle.
NOTE: Do not stop the washer during this spin. If you do, the fabric softener
will be added to the remaining soapy wash water. This can cause stains.
4. Clean the dispenser after each use with warm wafer. Do not use detergent,
if could cause dispenser to clog.
For more information on fabric softener, see page 12 in your “Laundry
Guide!’
11