Filter
Top Products
Other operating instructions
For a rinse and spin
For a drain and spin
You may need on extra rinse and
spin for heavily soiled loads which
need more detergent. (Extra de-
tergent can require an extra rinse.)
l
Push Control Knob in.
l
Turn clockwise to any
l
on the dial.
See above drawing.
l
Pull Control Knob out.
l
The washer will fill to selected
level: agitate 2 minutes; drain
and spin.
Your washer can be set to drain
and spin out water.
l
Push Control Knob in.
l
Turn clockwise to the bar just before
OFF in any cycle. See above
drawing.
l
Pull Control Knob out.
l
The washer will drain and spin.
For agitation and spin speeds in each cycle, see pages 6 -9.
For a soak or pre-wash
For best results, use warm water
for soaking or pre-washing stained
laundry. Hot water can set stains.
l
Use recommended amount of
detergent or pre-soak product.
l
Push Control Knob in.
l
Turn clockwise to point at a number
in the Soak Cycle . ..use the 4-minute
mark for a pre-wash.’
l
Pull Control Knob out to start washer.
l
When the cycle is over, add de-
tergent for the next selected wash
cycle. The SOAK Cycle should
always be followed by a Wash
Cycle.
Important: See additional care
information on page 7 of your
“Laundry Guide:’
10
‘To start soak or pre-wash with agitation, the Cycle Control Knob
must point to a number in the SOAK Cycle.