Filter
Top Products
5
n5. Leveling
• To access the front leveling legs, tilt the
machine backwards, leaning it against
a wall or other stable structure.
• Adjust the legs up or down (Fig. 8) to
ensure the washer is resting solid
and does not rock side-to-side or
front-to-back when the machine is
upright.
• Check that the angle of inclination,
measured according to the worktop,
does not exceed 2°.
IMPORTANT: The machine must rest solid on a sturdy floor
for optimum performance and minimum vibration.
IMPORTANT: Make sure that the drain hose is not kinked
and that water flow is not restricted.
Installation Instructions
WARNING: Splendide denies all liability if these instructions are not followed correctly.
A & B = 25" (62 cm) min. / 34" (86 cm) max.
Floor Standpipe Wall Standpipe
A
B
Fig. 4
Sink Drainpipe System - Entry into the sink drain system must be above
the trap (Fig. 5). When routing the drain hose through cabinets or walls,
use a protective material such as electrical or duct tape to cover sharp
edges that could damage the drain hose. Use a suitable clamp to secure
the drain hose to the “Y” branch or the disposer. With a sink drainpipe
system, you may connect directly: 1) to a disposer by following the
manufacturers attachment method. 2) directly to a “Y” branch tail piece
(available at most hardware stores). 3) Through the floor to a separate
trap. The trap must be vented to prevent siphoning. To provide proper
venting, install an Air Gap Kit (available at most hardware stores). 4) To
the to the faucet using a Faucet Adapter Kit (available separately). It will
supply water from your faucet and discharge water directly into your sink
drain.
25" (62 cm) min.
with an air break
Laundry Sink Drain
Fig. 5
Sink Drain W/ "Y" Branch Tailpiece
20" (50 cm) min.
with an air break
25" (62 cm) min.
34" (86 cm) max.
6" max.
Standpipe
Floor Standpipe
Fig. 6
U-Clamp
!
20" (62 cm) min.
34" (86 cm) max.
Standpipe
"Y" Tail Piece
This connection MUST be
before drain trap and at
least 20" (50.8 cm) above
the floor where washer will
be installed.
Cable tie
Floor Standpipe w/ "Y" Branch Tail Piece
Fig. 7
• Use a U-Clamp (provided in your accessories packet) or suitable item to
secure the outlet end of the drain hose (pre-installed on the back of your
machine).
• Insert the outlet end of the drain hose into the standpipe, wall or floor
drain (Fig. 6). NOTE: The outlet end of the drain hose MUST be at
least 20" (50 cm) above the base of the machine. No more than 6" of
the drain hose should be inserted into the drain pipe to prevent
siphoning.
• Use a strap, cable tie, or similar item to hold the hose or the U-Clamp in
place.
!
Fig. 8
n6. Electrical Connection
• Plug the power cord into a grounded outlet. See “Grounding
Instructions” (p. 2) for complete details. NOTE: Check to ensure the
power is OFF at a circuit breaker/fuse box before plugging the power
cord into the outlet. Turn power on at the circuit breaker/fuse box.
n7. Before Using Your Washer-Dryer
• Read manual thoroughly. Keep these instructions for future reference.
• Run the empty washer-dryer through a complete wash cycle to check for
water leaks and proper operation.
• Wipe the inside and outside of the appliance with a damp cloth to remove
any dust that has accumulated during transit.