Filter
Top Products
15
!
!
nHow to Dry Only
Once you have loaded the drum with the laundry that needs drying,
(see “Load Types/Sizes and Dry Times,” p. 12) make sure that:
• The door is closed correctly; The plug is secured in the socket; The
water supply is turned on; The On/Off button (I) is in the OFF (OUT)
position.
• Depending on the type of fabric being dried, turn the Program Selector
knob (A) clockwise until one of the three “Dry” programs is aligned with
the mark on the knob.
A spin cycle is carried out during drying if you select the
Cotton Heavy Duty dry program. For cotton loads of less
than 2.2 lbs., use the drying program for Permanent Press
fabrics.
• Set the Dry Time knob (C) to the desired dry time.
• Press the On/Off button (I) to turn the machine ON. The Status/Door
Lock lamp (L) will flash slowly for 5 seconds, then will light steady to
indicate that the program has been accepted.
At the end of the drying cycle:
• The Status/Door Lock lamp (L) will flash quickly for up to 90 seconds to
indicate that the cycle is finished, but the door is still locked.
• When the Status/Door Lock lamp (L) light flashes slowly, turn the washer-
dryer OFF by pressing the On/Off button (I).
• Open the door and remove your laundry (See “A Special Note About
Condenser Drying,” above on this page).
• After removing your laundry, leave the door open to allow for air
circulation inside the drum to avoid the formation of bad odors.
!
nHow to Wash & Dry Automatically
If you want your load to go automatically from wash to dry:
• Load the drum according to the recommended maximum load sizes for
drying. (See “Wash Through Dry Loads,” p. 12).
To protect your delicate fabrics, this machine will not
allow a dry program to be set when the Silk or Wool
program is selected.
IMPORTANT: To optimize the performance of your machine
when going from wash to dry automatically, always use fabric
softener during the wash cycle (“About Laundry Aids,” p. 10).
• Simply follow the instructions for wash only (see “How to Wash,” p. 15)
and set the Dry Time knob (C) before pressing the On/Off button (I).
Refer to the “How to Dry Only,” section on this page.
• The Auto Dry lamp (M) will light to indicate that the dry timer has been set
and at the end of the wash cycle, the appliance will run the selected
tumble drying cycle.
If the laundry load to be washed and dried is too large to dry,
then follow the instructions for wash only (see “How to Wash,” p. 14).
When the wash cycle has finished,you’ll need to remove some items (up
to 50%) after the wash cycle to give the remaining ones room to tumble
freely while drying. Now follow the instructions for dry only (see “How to
Dry Only,” this page). Repeat this procedure for the remainder of the
load.
Opening the door during the dry cycle: For your safety, the door
lock stays engaged for the duration of the dry cycle (see “Features,” p.
7). However, should you wish to open the door during the drying cycle,
you have two options:
• You can cancel the program by advancing the Program Selector knob
(A) to a “Reset” position and waiting 5 seconds. Pilot lamp (L) will flash
quickly, then slowly when the door lock is released. Now, turn the
appliance off and open the door. When finished, close the door and
follow instructions for dry only (“How to Dry Only,” this page).
•
Or, press the On/Off button (I) to turn the appliance off. Wait 1-2 min. for
the door lock to release, then open the door. When finished, close the
door and press the On/Off button again. The dryer will automatically
resume the selected program where it left off.
How to Dry
Operation Instructions
Warning:
-During the drying phase, the door tends to get quite hot. Do not
attempt to open the door when the door lock is engaged.
-Do not use the appliance to dry clothes that have been washed with
flammable or chemical solvents (e.g. trichlorethylene).
-This appliance can only be used to dry clothes that have been pre-
washed in water.
-Do not use the appliance to dry foam rubber or similar materials.
A Special Note About Condenser Drying:
"When you remove items from your dryer,
they may feel hot and humid to the touch.
This is a normal result of your machines
self-condensing drying process. Simply
shake them out and allow the humidity to
dissipate (this only takes a few seconds)
then fold or hang them immediately to
minimize wrinkling."