Smeg WDI16BA Washer/Dryer User Manual


 
GB
8
3.5 DRAIN CONNECTION
1. Insert the end of the drain hose into a drain pipe hav ing an internal diameter of at least 4 cm and a height
ranging between 50 and 90 cm, or attach it (using the relative curv ed plastic prof ile) to a basin or bath tub.
2. Always check that the end of the drain hose is securely attached in order to prevent the repulsive f orce of the
water f rom moving it out of position.
Attention!
Do not bend or obstruct the hose as this will reduce the f low of water.
Any extensions to the drain hose must not exceed 1 metre, they must hav e the same internal diameter and
must not be obstructed in any way.
In no circumstances should the end of the drain hose be submerged in water.
3.6 ELECTRICAL CONNECTION
Before fitting the plug into the socket, make sure that:
1. Input voltage matches that indicated on the name plate attached to the inner edge of the door.
2. The circuit-breaker, pressure relief v alves, power line and socket are capable of withstanding the maxi-
mum rated power input indicated on the name plate.
3. The socket is compatible with the plug supplied with the machine without the need to f it multiple sockets,
adaptors or extension leads that could cause ov erheating or burning.
If the socket does not correspond to the supplied plug, replace the socket with one of a suitable type.
Attention
The plug must be accessible after installation.
The appliance must be earthed. Plug the machine into a socket f itted with an efficient earth connection.
The manufacturer declines all responsibility for damage to persons or property resulting from
failure to earth the appliance or from a defective earth connection. Correct electrical connec-
tions guarantee maximum safety.
This appliance complies with EEC directive 89/336 of 3.5.89 (modified by EEC directive 92/31) relative to the
elimination of radio interference.
If the power cord is damaged, only replace it with an original spare part av ailable f rom our service depart-
ment.
Do not insert/remove the plug from the socket if your hands are wet.
Remove the plug from the socket by gripping the plug and not the cord.