Filter
Top Products
GB
20
U
Display information
When the machine is switched on, the display visualises
the duration (hours/minutes) and maximum spin speed
env isaged f or the programme. These two parameters are
display ed alternativ ely for 3 seconds each, together with
their relative LED's, until the selected programme starts.
Attention!
• The following partial washing programmes can be set
using the programmes knob:
-Rinse with additive
-Drain and spin
-Fabric softener
These partial programmes are inside the Cotton, Synthetics and Wool sectors, except f or the drain and spin
programme (Drain
)
.
• If the indicated temperature shows 0°, this means that the programme perf orms a cold wash cycle. The same
cold wash is also performed by the Hand wash programme in the Wool sector.
• The fabric treatment labels show which washing temperature must be set.
• If various garments in the same load require different washing temperatures, choose the lowest wash-
ing temperature of all.
• If the laundry is only slightly dirty and does not need the bleaching effect of high temperatures, a lower tem-
perature can be chosen to save power. In spite of the low temperature and consequent sav ing of electric-
ity, an automatic time control keeps the duration of the main washing unv aried compared with that of a high
temperature programme. It is theref ore possible to successf ully wash normally dirty laundry at lower wash-
ing temperatures than the maximum temperatures shown on the fabric care labels.
5.10 M ODI FYI NG STA RT I NG PA RAM ET ERS
5.10.1 SPIN SPEED
Press the select spin speed button ( ), the relativ e LED lights up and the display visualises the maximum speed
env isaged for the selected washing programme.
Press the button repeatedly. Speed decreases by 100 rpm ev ery time until the spin cycle reaches 0 rpm and is
disabled.
5.10.2 OPTIONS
Use the options buttons (indicated in chapter 4 – Description of controls, letter M) to enable machine options. A
selected option is highlighted by the option LED located above the button in question.
5.10.3 DELAYED START (ONLY FOR MODELS FEATURING THIS FUNCTION)
Press the delay ed start button (
). The relative LED located abov e the button lights up.
The display v isualises the time remaining (hours/minutes) bef ore the selected washing
programme starts: the display initially shows 0 hours 0 minutes for all programmes.
Press the button repeatedly. The Start delay increases by 30 minutes each time it is
pressed for the first 12 hours. After that it increases to 60 minutes up to 24 hours.
3 seconds 3 seconds
While selecting the delay ed start time,
y ou c an res et t he t im er by pressing the
button for at least 3 seconds.