Filter
Top Products
GB
14
G
Display
The display shows the following information:
1. time remaining for the selected programme, given
in hours/minutes.
2. delayed start (for models featuring this option).
Given in hours/minutes. When the time remaining
before the programme starts is less than 60 minutes,
this information is given in minutes/seconds.
3. spin speed
4. drying times given in hours/minutes
5. cycle pause - flashing STOP
6. end of cycle - END
7. error codes
To find out which of the first 4 pieces of information are
shown on the display, check which of the LED's, C, D, E, F or
S (the latter for models featuring the delayed start option) is
lit.
H
Select spin speed button or
stop with tub full
Press the button repeatedly to select the required spin
speed. The following spin speeds are available:
• 0000: spin disabled and stop with tub full. The ma-
chine does not perform the final spin and ends the
washing programme with water in the tub. To drain
the water, see the explanations shown in paragraph
5.13
• from 600 rpm to the maximum speed indicated for
the model: for cotton and coloured programmes,
speed increases by 100 rpm starting from 600 rpm
up to the maximum speed indicated for the model
• from 600 to 900 rpm: for synthetics, delicates and
woollens programmes, speed increases by 100 rpm
starting from 600 rpm up to 900 rpm.
I
Select programme and dry-
ing time button
Press the button repeatedly to select drying times up to a
maximum of 2 hours (120 minutes), with increments of 10
minutes, starting from 20 minutes. The type of drying cycle
can be selected with one of the following LED's:
• Delicate drying programme (letter E in this section):
drying temperature 60°C, for synthetic and delicate
garments.
• Intensive drying programme (letter F in this section):
drying temperature 90°C, for cotton and coloured
garments.
L
Select programme and dry-
ing time button enabled
LED
This LED lights up when drying times are being selected and
during the drying phase.