Filter
Top Products
EN
22
5.10.3 DELAYED START (ONLY FOR MODELS FEATURING THIS FUNCTION)
Press the delayed start button (
). The relative LED located above the button lights up.
The display visualises the time remaining (hours/minutes) before the selected washing
programme starts: the display initially shows 0 hours 0 minutes for all programmes.
Press the button repeatedly. The Start delay increases by 30 minutes each time it is
pressed for the first 12 hours. After that it increases to 60 minutes up to 24 hours.
5.11 STARTING THE WASHING PROGRAMME
1. Before starting the selected programme, carefully close the door, open the water tap and add the
detergent and additive
2. Press the “Start-Pause” button. The LED located above the Start-Pause button remains lit throughout the
cycle.
After starting, the display shows the time remaining until the end of the programme. The LED remains on
throughout the cycle.
If delayed starting has been set (only for models featuring this option), the display visualises the time
remaining before the cycle starts. When delayed starting is set, the relative LED flashes on and off.
5.12 INTERRUPTING OR CHANGING THE WASHING PROGRAMME
The washing programme may be interrupted at any time while it is running:
1. press “Start/Pause” for approximately 3 seconds: the display alternates between STOP (for 1 second)
and three horizontal lines (for 1 second) and the Start/Pause LED flashes.
The programme can also be stopped by turning the programme/temperature selection knob while the
cycle is running.
2. If you wish to change the washing programme, simply select the new programme by turning the
programme knob without pausing the machine first. The new washing cycle will be performed starting
from the beginning. If the tub is already full of water, the new programme will omit the filling phase.
3. To resume the cycle, press Start-Pause again.
Example
Example
While selecting the delayed start time,
you can reset the timer by pressing the
button for at least 3 seconds.