Filter
Top Products
EN
12
5. Fix the panel to the washing machine following the instructions shown below
3.7.4 Adjusting the hinges
If, after applying the panel to the washing machine, it is slightly inclined or off-centre with respect to the front of the
machine, correct its position by adjusting the mobile part of the hinges (see above).
3.7.5 Recessing the appliance
Push the washing machine into its recess. Turn the feet to horizontally, level the machine if necessary and lock
the counter nut with the relative check nut. To prevent vibrations from the machine from being transmitted to the
surrounding furniture, check that the sides and top of the appliance are unable to touch the furniture itself. There
must be a space of at least 2mm all around. The rear part of the machine must also remain some distance
away from the back wall. If the recessing cavity is higher than 820mm the opening between the floor and sides of
the machine (when this is installed at the end of a line of furniture), must be completely closed in compliance with
the relative safety provisions.
The covering must make it impossible for users to touch live parts of the electrical system and must require tools
in order to be removed.
Our company declines all responsibility for damages caused by failuresto comply with these safety provisions.