Filter
Top Products
13 14
T: 0800 0124 382 T: 0800 0124 382
INSTALLATION
ADJUSTING THE FEET
For safe operation, it is important that your Washer Dryer is level and securely positioned on
all four feet. Incorrect installation may cause the Washer Dryer to vibrate and increase your
water and electricity consumption. Never place cardboard, wood or similar materials under your
Washer Dryer to increase stability.
The four adjustable feet are used to level the Washer Dryer. To adjust the feet:
1
Loosen the plastic locking nut by turning anti-clockwise (fig 6a).
2
To increase the height of the machine, turn the feet anti-clockwise (fig 6b).
3
To decrease the height of the machine, turn the feet clockwise (fig 6b).
4
After making adjustments, use a spirit level to check that the machine is level.
5
Once the machine is level, tighten the locking nuts by turning clockwise (fig 6c).
WATER SUPPLY CONNECTION
Your Washer Dryer uses an energy efficient cold fill system, which means that only the water
required to wash the laundry is heated. As a result, no heat is lost in the pipeline from the hot
water supply.
Connect your Washer Dryer to your cold water supply only. If your previous machine had a hot
and cold fill, check that the hot tap on your water supply is closed to avoid leakage. Only use the
fill hose supplied and not one from your old Washer Dryer. Only one hose is required to install
your Washer Dryer to the cold water supply. The inlet hose provided with your Washer Dryer
connects the rear of your machine and the cold water supply.
To connect your Washer Dryer to the cold water supply:
1
Connect the angled end of the fill hose to the cold water inlet on the rear of your Washer
Dryer by screwing the threaded connector clockwise (fig 7). Take care not to overtighten the
connection. Hand tight is sufficient.
Figure 6
Figure 7
a:
b:
c: