Filter
Top Products
TF OUBLESHOOTnNG
WARNING: MANY OF THE ACTIONS YOU ARE ASKED TO CORRECT ARE PROBLEMS THAT INVOLVE CLEANING
A COMPONENT OF THE PRESSURE WASHER. WHEN CLEANING ANY PART OF THIS UNIT, TURN OFF THE UNIT
AND COMPLETELY DISCONNECT THE POWER SUPPLY.
PROBLEM CAUSE CORRECTION
Pressure Washer will not start 1 No electrical power is available.
2 Motor overheats.
3_ Low voltage
4_ Trigger not open
5. Electrical defect
Pressure Washer does not
come up to pressure
Highpressurespray isirregular_
Nointakeofcleaning agent.
1. Spraygun isinlow pressuremode,
2 Pumpis sucking all
3+ Water filter clogged
4 Pump notbled to removeair
5_ Pump isdefective
1_ Nozzle or water supply is restricted.
2_ Water supply inadequate.
1. Wrong nozzle setting
2. Nozzle clogged_
3, Detergent hose filter cloggecL
1. Check cable, plug, power socket
and fuse.
2 Press trigger of wand to relieve
pressure on the uni[
Allow unit to cool for about 2 min.
Itshould run when you turn it ON
again.
Length of extension cord is well
beyond 66 feel
3 Contact Sears Service Department
4 Open trigger
5 Contact Sears Sevice Department.
1_ Adjust nozzle to high pressure
mode.
2. Water hose must be 1/2" diameter
Make sure water supply is ON.
Make sure water supply is clean.
Check all connections for leaks or
blockage.
Tum OFF the unit, hold trigger in
OPEN position to relieve pressure
and allow air in line to escape With
tdgger still inOPEN position, tum
ON the unit Repeat if necessery_
3_ Clean filter_
4. Switch OFF washer, press trigger,
switch ON washer while pressing
tdgger Repeat if necessary.
5. Contact Sears Service Department.
1. Clean nozzle, check hose and
Screens_
2. Tum ON waterto full position.
Operatewasher in suction
operation with open container.
1, Adjust nozzle to low pressure mode_
2_ Clean nozzle.
3_ Clean tilterin detergent hose.
]2