Filter
Top Products
OPERATUON
TO TURN ON WASHER
WARNING: NEVER ADJUST SPRAY PATTERN
WHEN WATER IS SPRAYING. NEVER PUT HANDS
IN FRONT OF SPRAY NOZZLE TO ADJUST SPRAY
PATTERN. ALWAYS KEEP HANDS IN THE POSI-
TION SHOWN IN FIG. 9
CAUTION: Gun Idcks back. Use both hands.
WARNING: Risk of injury or injection to persons
-- Do not discharge stream at persons.
e Check that high pressure hose is attached to pump
outlet and that water supply is attached to pump inlet
(female connector of quick-connect).
o Turn ON water..Water supply should not exceed 104°F_
,= Press trigger on gun and wand assembly to force air
from high pressure hose (Fig. 12).
= Maintain trigger as shown in Fig 12 and press ON/OFF
switch.
©
IMPORTANT: DO NOT RUN PUMP WITHOUT THE
WATER SUPPLY CONNECTED AND TURNED ON OR
THE PUMP WILL BE DAMAGED°
SIPHONING
We do not recommend that you siphon your water supply
from sources other than from connecting to household
water supply.
TiPS
o Initially clean an area and then check the surface for
damage. If no damage is found, you can assume it is
okay to continue cleaning Detergents work best when
applied to dry surface.
o For most effective cleaning, keep spray nozzle be-
tween 8 to 24 inches of cleaning surface.
o Allow the detergent to soak in between 3-5 minutes
before washing and rinsing,
o For cleaning, start at lower portion of area to be washed
and work upward, using long, even overlapping
strokes
o
o
o
a
For rinsing, push the nozzle sleeve to high pressure
and wait for detergent toclear. Start at the top of area
to be rinsed, working down with the same action as for
cleaning.
Never use the garden hose inletto siphon detergent or
wax_
If you get the spray nozzle too close, especially using
high pressure mode, you may damage the cleaning
surface.
If you have the spray nozzle too far away, the cleaning
will not be as effective_
FIG. 13
CUSTONER RESPONSIBILUTUES
Do not get closerthan 6 incheswhen cleaning automo-
bile tires.
GENERAL RECOMMENDATIONS
The warranty of the high pressure washer does not cover
items that have been subjected to operator abuse or neg-
ligence. To receive full value from the warranty, operator
must maintain high pressure washer as instructed in this
manual
BEFORE EACH USE
DANGER : WATER SPRAYING FROM A LEAK IS
CAPABLE OF INJECTING MATERIAL INTO
SKIN. INSPECT HOSE EACH TIME BEFORE USING
IT. NEVER REPAIR HIGH PRESSURE HOSE. RE-
PLACE IT WITH ANOTHER HOSE THAT MEETS
MINIMUM PRESSURE RATING OF YOUR PRES-
SURE WASHER.
Check and Clean Quick-Connect Screen: Remove
quick-connect and examine the inlet screen on the female
connector. Clean if clogged or replace the quick-connect
inletscreen.
Check High Pressure Hose: High pressure hose can
develop leaks from wear, kinking, abuse. Check all hoses
for cuts, leaks, abrasions orbulging of cover, or damage or
movement of couplings. If any of these conditions exist,
replace hose immediately.
Check Detergent Hose: Examine the filter on the deter;
gent hose and clean if clogged. Hose should fit tightlyon
barbed fitting Examine hose for leaks or tears. Replace
the filter or hose if either is damaged.
Check Gun and Wand: Examine hose connection and
make sure it is secure. Test trigger by pressing it and
making sure itsprings back into place when released. Put
safety latch in ON position and test tdgger. You should not
be able to press tdgger.
]0