Filter
Top Products
20 SV61228 Rev. A
W983 Stacker/W863 Dryer Operating Guide
Stacker Tips and Troubleshooting
Cleaning
The Stacker requires a clean environment, free from dust, air borne
contaminants and moisture. Operator maintenance is limited to
clean ing the belts with a lint-free cloth dampened with a mild soap
and water solution.
Smudged Addresses
You can lift or slide any of the hold down rollers or springs where
heavily printed areas of your envelopes may be smudged by running
under the rollers/springs. Lift the roller/spring slightly and turn knob
to lock in place away from the conveyor belt.
NOTE: To assure the envelopes travel properly through the Stacker,
they must pass under the rollers and springs.
Jams
If mailpieces jam in the Stacker, the circuit breaker switch will auto-
matically shut the Stacker off. DO NOT press the power switch. With
the Stacker off, clear the jam and any remaining mailpieces. Wait 1 to
2 minutes before pressing the circuit breaker switch. The Stacker will
power back up automatically when you press the circuit breaker switch.
Fuse Replacement
If fuse replacement is required, turn the Stacker off, unplug the AC
power cord from the outlet and re place the de fec tive fuse with another
1.6 amp fuse. Fuse lo ca tions are shown in the illustration below. If the
blown fuse condition occurs again, call Pitney Bowes for service.
CAUTION: Disconnect power before replacing fuses.
Turn the power switch Off and unplug the power
cord from the AC power receptacle. For continued
protection against risk of fi re, replace only with same
type and rating of fuse.
Fuses
Stacker_Dryer Op Guide Book.indb 20Stacker_Dryer Op Guide Book.indb 20 3/30/2004 10:26:47 AM3/30/2004 10:26:47 AM