Filter
Top Products
13SV61228 Rev. A
W983 Stacker/W863 Dryer Operating Guide
Adjust Stacker Full Arm
This consists of making two adjustments: locating the full arm fixture
on the ramp and locating a metal tip on the full arm. There is a
scale on the ramp and one on the arm that are used to set up for
different size material. Refer to the table on page 15 to determine the
rec om mend ed values.
Arm Fixture
Scales
Knob
Arm
(knob under
ramp)
To adjust the full arm fixture on the ramp:
• Loosen the knob on the bottom of the ramp holding the fixture.
Move the fixture so that the lower end of the box aligns with the
desired value on the scale. Refer to tables and graphs on pages
15-19 to determine the value. Tighten the knob when you are
finished.
To adjust the full arm metal tip:
• Loosen the knob holding the metal tip to the arm. Slide the knob
to the desired value on the scale. Refer to the table on page 15
to determine the value. Tighten the knob when you are finished.
Stacker_Dryer Op Guide Book.indb 13Stacker_Dryer Op Guide Book.indb 13 3/30/2004 10:26:45 AM3/30/2004 10:26:45 AM