Filter
Top Products
18
Consumer Support
Troubleshooting Tips Operating Instructions Safety InstructionsInstallation InstructionsTroubleshooting Tips Installation Instructions Safety InstructionsOperating InstructionsTroubleshooting Tips Installation Instructions Safety InstructionsOperating Instructions
Before you call for service…
Troubleshooting Tips
WATER POSSIBLE CAUSES WHAT TO DO
Too many suds Type of detergent • Switch to a lower sudsing detergent brand and follow
instructions on package.
Very soft water • Try less detergent.
Too much detergent • Measure your detergent carefully. Use less soap if you
have soft water, a smaller load, or a lightly soiled load.
Water leaks Fill hoses or drain hose is • Make sure hose connections are tight at faucets and the
improperly connected washing machine. Make sure the end of the drain
hose
is correctly inserted in and secured to the drain.
Household drain may • Check household plumbing. You may need to call
be clogged a plumber.
Constant water pressure • Tighten hoses at the faucets and turn the water off
to the fill hoses at the after each use.
water source
• Check condition of the fill hoses; they may need
replacement after 5 years.
Using too much detergent • Use less detergent. Use less soap if you have soft water,
in washer a smaller load, or a lightly soiled load.
Water temperature Water supply is turned off • Turn both hot and cold faucets fully on and make sure
is incorrect or improperly connected hoses are connected to correct faucets.
Water valve screens are •
Turn off the water source and remove the water
stopped up
connection hoses from the upper back of the washer.
Remove screens and use a brush or toothpick to clean the
screens in the machine. Reinstall screens, reconnect the
hoses and turn the water back on.
House water heater is • Make sure house water heater is delivering water
not set properly at 120°F.–140°F.(48°C.–60°C.).
Water won’t drain Drain hose is kinked or • Straighten drain hose and make sure washer is not
improperly connected sitting on it.
• Top of drain outlet should be less than 8 ft. above floor.