Filter
Top Products
16
TO DISCONNECT THE WASHER:
TO CONNECT THE WASHER:
If you have two separate water connections, your washer
can be connected to both the hot and cold water faucets.
This kit can be purchased from your dealer or from Parts
and Accessories. In the United States, call 800.626.2002.
In Canada, consult the yellow pages for your local Camco
number.
WASHER CONNECTIONS FOR PORTABLE MODEL
WSLP1100—TWO-FAUCET CONNECTIONS
CONNECT TO WATER LINE
1
Connect HOT and COLD water inlet hoses to the
HOT and COLD faucets.
Cable
Tie
Cable Tie
Sink
Stand Pipe
Secure the drain hose to the sink or stand pipe.
CONNECT DRAIN HOSE
2
PLUG THE POWER CORD INTO A
3-PRONG GROUNDED OUTLET
3
Insure proper ground
exists before use
TURN WATER FAUCETS OFF
1
UNPLUG POWER CORD AND
RETURN IT TO THE STORAGE
AREA
2
DISCONNECT THE DRAIN AND
WATER SUPPLY HOSES
3
Hang them on the storage rack.
Installation Instructions
INSTALLATION CHECKLIST
4
Before starting the washer, check to make sure:
❏ Main power is turned on.
❏ The washer is plugged in.
❏ The water faucets are turned on.
❏ The unit is level.
❏ The drain hose is properly tied up.
❏ There are no leaks at the faucet, drain line
or washer.