Filter
Top Products
16
How to install
Placement
Socket outlet
Establish a ground (In case of two-wire power cords)
• When there is a grounding receptacle on power supply
outlet.
• When carbon ground rod (sold separately) is used.
• Do not connect to gas pipe, water pipe, or ground wire
of telephone or lighting rod.
• Reestablish a ground when you change installation
location or move.
• For further information, contact the distributor or service
technician.
Grounding
receptacle
Ground
wire
Carbon
ground
• Do not install the washing machine in any extremely damp place such as a bathroom, or in a place
exposed to the weather. There is a danger of electric shock, fi re, machine trouble and deformation of
machine.
• If machine is installed on the fl oor, be sure that carpet does not block any openings to prevent it from
closing any ventilation openings.
• Do not install the washing machine exposed to direct sunlight (This could cause machine trouble,
deformation and other problem.)
Install Washing Machine Horizontally
1
Place the washing machine on a fl at and secure location.
2
Open the lid, leveller is already fi x on the Plastic Body surface. Visually check
that the bubble of the leveller is inside the mark from the front and top.
• There is no need to make
a height adjustment.
Plastic Body
Leveller
3
Adjust height
When the bubble is largely out of mark
• The fl oor is largely inclined against the
direction that the bubble is leaning.
• Let the bubble inside the mark by
placing a board under the leg on the
other side.
Board or a like
When the bubble is a little out of mark
(Bottom view)
Front side
Adjust using
adjustable leg
4
Check the machine for unsteadiness and tightens the adjustable leg knob.
1. Turn the Adjustable Leg Knob towards
(LOOSEN) direction to loose it.
2. Turn the Adjustable Leg to adjust the
levelness.
• When increasing height, turn Adjustable
Leg towards (LOOSEN) direction.
• When decreasing height, turn Adjustable
Leg towards (TIGHTEN) direction.
3. Turn the Adjustable Leg knob towards
(TIGHTEN) direction to tighten it.
Tighten
Adjustable leg knob
Loosen
Adjustable leg
To raise
To lower
Bubble
Mark
When the bubble is inside the mark
Power cord
• Make sure to push the power plug completely into the socket outlet. If the power plug
is not completely pushed into the outlet, this will cause electric shock and fi re due to
overheating.
WARNING
Make sure to establish a ground.
There is a risk of electric shock
caused by a leakage of electricity.
NA-F62-70B1-ENABPS.indd 16NA-F62-70B1-ENABPS.indd 16 5/8/08 9:16:44 AM5/8/08 9:16:44 AM